/BdwlkjNews.asp?id=1333 中频炉逆变电路不能启动或启动困难的维修(英文版) - 豪门会彩票,豪门会彩票app

设为首页 设为收藏

联系方式

 

洛阳松导感应加热科技有限公司 

联系方式:15038554363  

24小时技术热线:15038554363

电 话:0379—60125771

邮 箱:1390003299@qq.com

厂址:河南省洛阳市洛新工业园区

  • 产品
  • 1吨塞棒底注式中频电炉

    管端加厚生产线

    合金熔液搅拌电炉

    12吨中频感应熔炼炉

    茶壶5吨熔铝中频炉

    0.5吨逆变串联中频炉

    串联谐振2吨中频炉

    钢坯补温提温加热炉

    钢坯感应加热炉

    雾化定点浇铸炉

    智能控制1吨中频炉

    智能控制3吨中频炉

    智能控制5吨中频炉

    5吨一拖二中频炉2018

    1吨称重管理中频炉

    中频感应精炼炉

    一拖二0.5吨中频炉

    0.75吨一拖二中频炉

    1吨串联中频炉

    2吨拖二中频炉

    3吨拖二中频炉

    0.5吨中频熔炼炉

    0.75吨中频熔炼炉

    1吨中频熔炼炉

    3吨串联中频炉

    1吨一拖二中频炉

    0.75串联中频炉

    1吨串联中频炉

    中频电炉维修
    分享到:
        本文为技术资料或者文章来自网络,仅供参考学习,如涉嫌侵权,请告知删除
        

     

     

     

    中频炉逆变电路不能启动或启动困难的维修(英文版)

    ault phenomenon of induction melting furnace

    The inverter circuit of the IF power supply cannot be started or started up.

    Fault analysis and processing

    The main reason why the inverter circuit of the IF power supply cannot be started or started is as follows.

        (1) Short circuit between induction coils. If the induction coil does not cool well for a long time, the insulation is broken and a short circuit between turns is caused. Conductive materials such as dust and scale on the induction coil can also cause short-circuit between turns. When the intermediate frequency power supply is started, the ignition phenomenon occurs, and frequent ignition may cause the induction coil to break down. In this case, the surface of the induction coil should be cleaned, brushed with insulating paint or asbestos board.

        (2) The induction coil is short-circuited to the arc furnace casing. The induction coil housing is loose and there is too much ash in the furnace; the induction coil is discharged through the furnace base. In this case, the induction coil should be reinforced to remove dust.

        (3) The copper busbar connected to the induction coil at the intermediate frequency output is short-circuited. If there is a foreign object or the copper is not fixed, it may cause a short circuit between the copper rows.

        (4) The capacitor case is short-circuited to the ground. At this time, it should be checked whether there is water leakage, whether the capacitor base is too dusty, and whether the ceramic base of the capacitor is missing.

        (5) The water-cooled cable is disconnected, and the copper bus that is output to the load is blown.

        (6) Check if the current transformer insulation is damaged; remove the current transformer to check whether the insulation is good; use a multimeter to measure whether the coil is blown, and check if the wiring sequence is correct. If both are normal, check whether the potentiometer of the current signal adjustment is too small. The amplitude of the output current signal should be re-adjusted.

    (7) Check if the inverter circuit's inverter angle is too small. If it is too small, adjust the inverter angle; if it is normal, check if the current polarity is reversed. If not, check the inverter thyristor for a trigger pulse. If it is normal, check the inverter thyristor for damage. If it is damaged, replace it with a thyristor of the same type and specification.

    http://www.firstfurnace.com//BdwlkjNews.asp?id=1398

     


    Copyright© 2007-2013洛阳松导感应加热科技有限公司 All Rights Reserved 
    电 话:0379—60125771 手 机:15038554363
    网站正在制作中,随时修改,非正式运行。
    本站关键词:豪门会彩票,豪门会彩票app、熔炼炉